Reference "CEN" alone installation navigation BMW GT1 multifunction, tired "experience

CEN to the installation BMW GT1 alone navigation multifunction, tired of study are, to determine their own installation a navigation, online taobao a Station Road, shi, the wide-angle CCD camera, a total of 1800 ocean. According to the above basic, have some supplementary. New sunshine road, shi camera

First, pry medium cover, I must first make clear what prize which slot, from intermediate to both sides of the third slot. The up and down or so four Angle, according to the lower left and lower right, upper left, upper right order pry up.

Second, use the special offer pry plate the best, if not, use the screwdriver bread plastic can also, it is easy to scratch, careful prize.

Third, a thread from is connected to the control panel rear, attention should be paid to don't take panel   BMW GT1 avulsion too far.

Fourth, the connection of the original radio socket and a antenna feeder socket, respectively inserted into DVD navigation provides the conversion online, again by conversion line access DVD navigation. The antenna feeder jack from the pull on the radio, must be careful, there is a little swan, don't brute force (I'm pretty force, broken now, there is no radio to listen to, the 4 s store said there was no the bayonet change, to change the whole antenna feeder, 55 sheep, wait for half a month.

Fifth, a lot of with the wiring harness, directly insert another DVD ports, except of reversing the video input, do not need other any attachment.

Sixth, camera extension cord only a plug at the end of the received astern video on with a lid on the plug.

Seventh, camera extension  BMW GT1  cord only a plug of a have a thread, received DVD navigation provides the conversion online brake control the root online, like pink, enveloped in adhesive tape.

Eighth, camera extension cord has two plug from one end of the camera head, at the rear trunk the original license plate lamp position.

Ninth, camera extension cord has two plug one end of the two lines, one black, one red, black take iron, red received a camera and reversing light on. That is using reversing light 12 v high level to camera power supply, to front brake control transfer astern start signal.

The first ten, my connection method is such, red line end received camera head, trunk with open, it is not enough to distance connection to the body the lower right corner of the fall of the Lexia-3  lamp. So, I put the black line pull down, from the middle of the red line site access, the other end access back-up light of the root wiring harness, as is yellow.

Eleventh, red one end of the line, and then in the camera head, cent gives way to backup light, the other end up in the back line.

12, after loading must put the body in the position, casing and the car hob contact, to form circuit boot.

13, I DVD navigation position somewhat offset, central shell cover not up, I use the brute force, first put the following cover, in above with panting, DVD navigation extrusion.