Some Cherokee owners BMW GT1 will encounter depress the clutch pedal, hanging forward gears normal linked to reverse gear is not good hanging into, and accompanied by the sound, which cause the clutch is not complete.
Solution: check the clutch master cylinder and the slave cylinder oil leaks, clutch friction plate is intact. If these are normal parts, clutch pressure plate at the foot of shimming. If the previous gear are well linked into a gear and reverse gear suddenly bad hanging in, and the shift lever when Guadang heavier, and accompanied by a slight noise, this phenomenon is normally provided by the engine mount pad rupture caused by the need to replace the engine mounts. This failure can not be ruled out, the need for timely repair station maintenance.
6 sea temperatures.
Solution: BMW GT1 Cherokee use three or four years, the problem of rising sea temperatures may occur. The method starts from the flush tank cooling louvers. If the effect is not obvious then check the water temperature sensor, generally if the sensor problem will be accompanied by the phenomenon of black smoke, fuel consumption, power down together to produce. If the above two points no problem, you can check the water tank on the front of the electronic fan is working, as well as the water tank is fouling too much, thus affecting the cooling of coolant circulation.
7 vehicles in remote areas, in the case of no repair facilities encountered a the tank or ministries reservoir
BMW GT1 leakage.
Solution: chewing gum or soap smear, allows the vehicle to insist on running for some time at the leak.
没有评论:
发表评论